Hive wiring

[Lawyered07]

I have a dual channel hive programmer to install. Currently have a corgi programmer with wiring below

There is no heating off wire which would go into terminal 5. I read on another thread that Hive didn't necessarily need that...is that correct? I couldn't find anything which covered that for sure on any other thread.

I also have a wired thermostat which I am planning to bridge out, if that makes any difference.

So can I connect up without "heating off" wire?

Thanks

 

[Mister Banks]

The Hive should be a direct swap.

Ignore me, I had the wrong backplate in mind, .

 

[bernardgreen]

The Hive should be a direct swap.

May not be a direct swap.

Some re-wiring may be necessary

The pin out ( terminal assignment ) on the Hive is not the same as that of the existing corgi programmer diagram

 

[CBW]

For some reason, I can’t see the images, if you have an s plan (x2 motorised valves) then should be ok.

 

[Mister Banks]

May not be a direct swap.

Some re-wiring may be necessary

The pin out ( terminal assignment ) on the Hive is not the same as that of the existing corgi programmer diagram
View attachment 293423

I think you are right, I will edit my post.

 

[ianmcd]

you will never need a CH off wire unless the system also has air con

 

[Lawyered07]

Thanks for all the replies. Happy with switching the existing wiring round but wasn't sure what to do about the missing wire