How to fit pressure relief valve
- Thread starter Gary111
- Start date
Sponsored Links
You probably need a couple of these:
https://www.screwfix.com/p/flomasta-compression-adapting-male-coupler-15mm-x-/69358
Or, if the photos are of the one being replaced, use those fittings!
...but I may be wrong
...and talk about 'Low-battery anxiety'
https://www.screwfix.com/p/flomasta-compression-adapting-male-coupler-15mm-x-/69358
Or, if the photos are of the one being replaced, use those fittings!
...but I may be wrong
...and talk about 'Low-battery anxiety'
If this is a safety device for a boiler or unvented HW then given you need to ask what's needed to fit it, can I suggest you get a professional to install it. If not fitted correctly it may fail to operate properly and leave whatever it is protecting potentially dangerous to you and yours.
Sponsored Links
As said it is a safety device and not a DIY job so advice on here is against site rules
My apologies,
It was late and I treated it as a simple query about connections, rather than questioning the competency of the OP to replace C/H safety devices.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
