Has anybody got any suggestions on installing a new consumer unit split load board, which will replace the old fuse board. The problem that i envisage is that the wires in the exisiting CU have been trimmed really short and i know from the outset that these will not reach all of the requaired terminals in the new CU.
I have thought about wiring the old wiring to some sort of 100A block and then taking new wiring from there to the new CU. i will then have no problems wiring up.
Can anybody offer any help in extending the wires or advise on whether there is a product out there that will fulfill my needs.
Thanks in advance.... Glad to be back
I have thought about wiring the old wiring to some sort of 100A block and then taking new wiring from there to the new CU. i will then have no problems wiring up.
Can anybody offer any help in extending the wires or advise on whether there is a product out there that will fulfill my needs.
Thanks in advance.... Glad to be back