We've just purchased a new oven and ceramic hob and are in the process of installing it.
The old all in one electric cooker was hooked up to a 30amp radial circuit via a connector unit.
The rather confusing instructions that cames with the hob say that it needs to by fused to 20amp. What's the best way of doing this without too much effort, but safely of course?
Just out of interest the oven instructions say that it needs a 13amp fuse.
Could we wire the hob into the connection unit and plug the oven into the same unit or would that mean the hob wasn't protected properly as we have a 30amp fuse at the consumer unit end?
Any ideas?
The old all in one electric cooker was hooked up to a 30amp radial circuit via a connector unit.
The rather confusing instructions that cames with the hob say that it needs to by fused to 20amp. What's the best way of doing this without too much effort, but safely of course?
Just out of interest the oven instructions say that it needs a 13amp fuse.
Could we wire the hob into the connection unit and plug the oven into the same unit or would that mean the hob wasn't protected properly as we have a 30amp fuse at the consumer unit end?
Any ideas?