Got the floorboards up on our suspended ground floor.
Sleeper walls, airbricks, 4x2 joists, the usual setup.
Going to be insulating between joists with 4" rockwool.
Currently have 2.5mm T&E feeding 9 downstairs double sockets, with a spur for a single outside socket. The cables are currently clipped to sides of joists, so they will end up buried in the insulation.
I will replace all the cable runs like for like with new cable, what's the best way to route them? I have a few lengths of 20mm galv conduit available.
Could I clip these underneath the joists and run the t&e through them?
We get the occasional mouse/rat in the house so I don't want to leave the cable too exposed.
I have no bending facility and don't want to terminate the conduit into every socket box 'door to door', but just have the open end of the conduit beneath the floor within the vicinity of the socket.
Sleeper walls, airbricks, 4x2 joists, the usual setup.
Going to be insulating between joists with 4" rockwool.
Currently have 2.5mm T&E feeding 9 downstairs double sockets, with a spur for a single outside socket. The cables are currently clipped to sides of joists, so they will end up buried in the insulation.
I will replace all the cable runs like for like with new cable, what's the best way to route them? I have a few lengths of 20mm galv conduit available.
Could I clip these underneath the joists and run the t&e through them?
We get the occasional mouse/rat in the house so I don't want to leave the cable too exposed.
I have no bending facility and don't want to terminate the conduit into every socket box 'door to door', but just have the open end of the conduit beneath the floor within the vicinity of the socket.