Kitchen reconfiguration difference unit heights

[Joel bridger]

Hi All

I’m having a new extension build and was hoping to reuse my existing kitchen which is only three years only and instead of being a u shaped kitchen would now be reconfigured into a straight linear kitchen with the ladder units at one side in a block.

problem is I have just realised that my ladder units are all slightly different heights and will look a mess. Any ideas on how to hide these changes in level?

All I can think is a cornice with an infil piece where the gaps appear below.

 

[chris1982]

Can't you adjust the feet on the cabinets?

 

[motorbiking]

What is significantly different in cm/mm? Can you raise the feet? Build on a wine bottle shelf unit etc?

 

[Joel bridger]

Yeah I thought that but wondered about the plinth then, suppose of the two elements that’s the least obvious

 

[Joel bridger]

But then the side panels would still be to short or long

 

[motorbiking]

As long as the doors line up. You can pack everything else.

 

[Joel bridger]

I suppose I’d have to hide the fact that the side panels No longer touch the floor by putting the plinth over them

 

[Joel bridger]

Hi Motorbiking - the difference is 15mm on one and 40mm on the other