So I am attempting to make a nicer area of the garage with 2 appliances, 2 base units and a worktop. Potentially adding a wall unit too.
This is what I have so far... pic below...
I have made a bit of a stud wall to space the units out so I have a nice flat rear panel.
Question is what to use to clad the back panel. I don’t want to bother with plasterboard/plastering. I was thinking 9mm ply. But obviously all the screws will be visible.
Any other ideas?
This is what I have so far... pic below...
I have made a bit of a stud wall to space the units out so I have a nice flat rear panel.
Question is what to use to clad the back panel. I don’t want to bother with plasterboard/plastering. I was thinking 9mm ply. But obviously all the screws will be visible.
Any other ideas?