We had a new worktop and sink fitted about 18 months ago, we have just noticed that the laminate is starting to lift (like a a 1" square blister) at one end of the sink.
Any ideas how to cure this, it looks like the seal wasn't fitted properly under the edge of the sink.
I thought if I could remove the sink I could put some adhesive in (if there is a gap) then cramp it down. Seal all round cut edge of worktop and replace sink
Any ideas how to cure this, it looks like the seal wasn't fitted properly under the edge of the sink.
I thought if I could remove the sink I could put some adhesive in (if there is a gap) then cramp it down. Seal all round cut edge of worktop and replace sink