Hi all,
New to this forum but hoping for a little help.
Wiring up 3 new ceiling rose lights in my loft and the whole loop system is obviously confusing me!
So currently wired up a switch from an existing rose on the landing. Live to switch, neutral to neutral and earth to earth. The latter two via terminal block.
Then live from the switch to the loop section of the first light and then the n and e to the right part.
For the other two lights I have continued to use the loop.
When switched on the first light works but that's it.
Is there any reason why I have to use the loop part. Can I not just wire live to live and ignore the loop part of the fitting?
Any advice would be greatly received!
Thanks
Simon
New to this forum but hoping for a little help.
Wiring up 3 new ceiling rose lights in my loft and the whole loop system is obviously confusing me!
So currently wired up a switch from an existing rose on the landing. Live to switch, neutral to neutral and earth to earth. The latter two via terminal block.
Then live from the switch to the loop section of the first light and then the n and e to the right part.
For the other two lights I have continued to use the loop.
When switched on the first light works but that's it.
Is there any reason why I have to use the loop part. Can I not just wire live to live and ignore the loop part of the fitting?
Any advice would be greatly received!
Thanks
Simon