My GXI-3000 appears to have died.
There was a '2' in the Fade display box, and the unit didn't respond.
I pressed all the buttons and the 2 went.
The only response I get out of it is when I hold down the Zone 1 and Zone 2 down buttons.... all the LEDS on the panel light up.
I have tried disconnecting all the lighting circuit zones in case there was a short, but that doesn't seem to work.
Any one got any ideas?
Or is there anything I can replace it with temporarily while I wait for a RTB?
Running off it I have 12V Halogens.
4 zones
Zone 1 9 Halogens x50W
Zone 2 4x50W
Zone 3 8x50W
Zone 4 4x50W
Can I just replace one of those zones with a simple switch just to give me some light for temporarily? Or a 4 gang switch?
Thanks for any help.
There was a '2' in the Fade display box, and the unit didn't respond.
I pressed all the buttons and the 2 went.
The only response I get out of it is when I hold down the Zone 1 and Zone 2 down buttons.... all the LEDS on the panel light up.
I have tried disconnecting all the lighting circuit zones in case there was a short, but that doesn't seem to work.
Any one got any ideas?
Or is there anything I can replace it with temporarily while I wait for a RTB?
Running off it I have 12V Halogens.
4 zones
Zone 1 9 Halogens x50W
Zone 2 4x50W
Zone 3 8x50W
Zone 4 4x50W
Can I just replace one of those zones with a simple switch just to give me some light for temporarily? Or a 4 gang switch?
Thanks for any help.