Hi all,
I installed new drainage as part of an extension earlier this year. The fall on the chamber is a little bit steep, as we had to go inline to an existing drain run (Now removed).
Currently, only the top right inlet is in use for bathroom and kitchen, the straight inlet isn't connected to anything yet.
A week ago I cleaned the chamber, but after a week it looks like this again (Sorry, it's horrible, click the thumbnail if you're not eating!)
It stays about this bad. I'm wondering if the connections being back-dropped by about 60cm, is, 'accelerating' the waste, and throwing it across the chamber?
Is this normal? Or do I need some sort of covers inside for the unused inlets?
Thanks, and sorry for any wasted lunches.
Tim
I installed new drainage as part of an extension earlier this year. The fall on the chamber is a little bit steep, as we had to go inline to an existing drain run (Now removed).
Currently, only the top right inlet is in use for bathroom and kitchen, the straight inlet isn't connected to anything yet.
A week ago I cleaned the chamber, but after a week it looks like this again (Sorry, it's horrible, click the thumbnail if you're not eating!)
It stays about this bad. I'm wondering if the connections being back-dropped by about 60cm, is, 'accelerating' the waste, and throwing it across the chamber?
Is this normal? Or do I need some sort of covers inside for the unused inlets?
Thanks, and sorry for any wasted lunches.
Tim