Menvier TS2400 - reset HELP

[jigp]

Hi,

Please can some help.... i have an old menvier TS2400 alarm, it showed a battery fault on the keyboard, assuming the one of the batteries died and then the bell went off, waited 20 mins and for it to stop. The next day I replaced the battery in the control panel and there is a secondary battery which I replaced as well. They keyboard didnt power up. It has powered up now but only shows the Menvier Security version 4.1 and the keyboard buttons work but no change from this message. Any ideas? I have the engineer code, but as the keyboard is not responsive, I'm not sure what to do, dont want to really do.a hard reset as will need to be programmed. Thanks.

 

[Wayners]

Not my area of knowledge.
However.
Try the default engineers code 1234.

Might be other common ones for that alarm if you look online

 

[Wayners]

Looking online if you can't work out engineers code you can hard reset it. Instructions online

 

[jigp]

I have the engineers code..

 

[sparkymarka]

Check you haven’t pulled out a wire on the keypad bus in the panel

 

[mikehammer69]

2113 or 2213 I can't remember maybe