Hello guys,
I have knocked up the attached layout for my living room. The drawing is to scale.
Room dimensions are 4.4 x 3.2m.
The engineered boards are 180mm wide x 1800mm long - they have a bevelled edge so I feel it is important to get the layout spot on since the lines will of course be very visible. I want to make sure I have good cuts and the staggering looks ok.
I would really appreciate your comments on the layout and welcome any feedback on how this could be improved?
Note: The boards will not fully run under the hearth as this is going to be cemented to the concrete floor. I'm planning to run the boards 30-50mm underneath the hearth and then terminate them.
Thanks in advance.
Claire.
I have knocked up the attached layout for my living room. The drawing is to scale.
Room dimensions are 4.4 x 3.2m.
The engineered boards are 180mm wide x 1800mm long - they have a bevelled edge so I feel it is important to get the layout spot on since the lines will of course be very visible. I want to make sure I have good cuts and the staggering looks ok.
I would really appreciate your comments on the layout and welcome any feedback on how this could be improved?
Note: The boards will not fully run under the hearth as this is going to be cemented to the concrete floor. I'm planning to run the boards 30-50mm underneath the hearth and then terminate them.
Thanks in advance.
Claire.