A friend of mine is fitting me a full new system including underfloor heating, I know nothing about plumbing does is look a good install?
Where is the pressure reducing valve (control group) for the cylinder (is your friend G3 certificated)
Erm no.You sure this is not at a training centre and you are just showing off your latest pipework?
Why all the soldered fittings? Why not use pulled bends?
I don't think there are any air vents, should this have come with all my underfloor heating stuff?Just seen second pic, ufh circuit looks like a potential air-lock - unless my eyes are just not good enough to see the air vents.
Looks a fine installation to me! the PRV control group is above the boiler in the first pic, no problem with that,
as for the underfloor manifold there is a manual; air vent on the end of the top manifold so no air problem there either,
I would be happy to maintain this system remember to lag the pipes in the boilerhouse when its all completed and tested
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local