First post on here, so apologies if this has been asked before.
I've been trying to follow advice gathered on here about painting 2 previously woodstained internal 6 panel solid doors - and they're now white!
However I've been using a roller and I'm not too pleased with the orange peel effect finish achieved after 4 coats. If I sand down again should I use a brush or have I been using the wrong roller (small rad type). I suppose my question is can you get a good flat finish using a roller and if so what type of roller?
Any other hints/tips because I've done 2 doors and got another 6 to do.
Thanks for any advice
I've been trying to follow advice gathered on here about painting 2 previously woodstained internal 6 panel solid doors - and they're now white!
However I've been using a roller and I'm not too pleased with the orange peel effect finish achieved after 4 coats. If I sand down again should I use a brush or have I been using the wrong roller (small rad type). I suppose my question is can you get a good flat finish using a roller and if so what type of roller?
Any other hints/tips because I've done 2 doors and got another 6 to do.
Thanks for any advice