Paddle Mixer Bricklaying Mortar

[Dave1UK]

So today I done pointing on a garden brick wall before I lay some additional bricks on it. I wasn't too happy with the consistency of the mortar and wondering whether I'm doing something wrong/maybe made it too dry or could the issue be using a paddler mixer as opposed to mixing by hand?

I used a 4:1 ratio of building sand, cement and a splash of plasticiser and water (gradual). I used those household 1L cooking measuring jugs mixed 8 sand and 2 cement if that helps to get a better idea. In terms of the total water refilled bottled water and was probably about 700ml?

Mixed the sand and cement dry with paddle mixer low speed. Added a splash of plasticiser slightly faster speed, gradually started adding water and mixing. I got to a stage where I didn't want to add more water to ruin it. However the mixture wasn't butter smooth like you see on YouTube? It wasn't lumpy either a little bit gritty but it didn't crumble, held it's shape when squeezed.

I was able to do the pointing and overall to the eye it seems fine but just wondering whether the mix may have been compromised or how I can improve it?

Thanks.

 

[23vc]

Probably not enough water. The quoted amount of water you used is a bit meaningless as it totally depends on how wet the sand from the bag is. When you say padel mixer do you mean on the end of a drill?
If it’s got a bit of a gritty feel and it’s definitely building sand, my moneys on a little bit more water/plasticiser needed…

 

[^woody^]

Are you sure that's building sand? It looks a bit yellow. Building sand would normally be more red/brown.

Some places sell building sand which is actually really sharp sand and that can make crap unworkable mortar

It's impossible to "compromise" a mix. It does not matter what is used to mix it, how it is mixed or how the ingredients are added. If it's all mixed together properly and uniformly then it should be fine.

 

[Dave1UK]

Probably not enough water. The quoted amount of water you used is a bit meaningless as it totally depends on how wet the sand from the bag is. When you say padel mixer do you mean on the end of a drill?
If it’s got a bit of a gritty feel and it’s definitely building sand, my moneys on a little bit more water/plasticiser needed…

Sand in the bag wasn't that wet if at all as has been out in the "sun", based in London.

An actual dedicated paddle mixer (attached photo).

Yeah I bought the sand from Wickes over a week ago. Will take a photo of the bag tomorrow. It's definitely building sand as I have 2 tonne bags of sharp sand but can't use that for bricklaying so got building specifically.

In terms of plasticiser if I recall the instructions said 100ml for 25kg of cement i.e. basically a full bag, I probably put like 25ml in a small mix probably 2KG of cement. Can I ever put too much which would impact the mix?

Are you sure that's building sand? It looks a bit yellow. Building sand would normally be more red/brown.

Some places sell building sand which is actually really sharp sand and that can make crap unworkable mortar

It's impossible to "compromise" a mix. It does not matter what is used to mix it, how it is mixed or how the ingredients are added. If it's all mixed together properly and uniformly then it should be fine.

Bought it from Wickes over a week ago, building sand. Will double check tomorrow but I'm sure it is.

Will take a few photos of the sand itself as well as if the sand itself may be at fault don't want to be using that for building anything!