Picture of the week!™

[RF Lighting]

Well folks, it's that time of the week again!

This week is a TP dist board in a commercial garage.

When it was installed it would appear the installer did not have any TP MCBs, so three SP MCBs have been used, and linked by fitting some plastic over the levers.

I don't know if you can see, but MCBs 3, 4 &5 from the top on the right hand side are 32A SP MCBs feeding a TP grinder. It is wired in 4G0.75mm² SY flex

The only TP MCB in the board feeds a 63A CEEform socket with TWO phases for a 415V SP welder.

Its also a horrible mess.

 

[oharaf]

RF I have just had 6 pints of SHEEP, but is that an earth going to the 2nd pole of the Isolator?

 

[333rocky333]

There the square D qoe ones, were they not made with that red plastic bit on them.
I am sure I have seen them before like that

 

[Lectrician]

RF I have just had 6 pints of SHEEP, but is that an earth going to the 2nd pole of the Isolator?

Looks like a 16mm yellow to me Does have a shadow on it.

 

[Lectrician]

This DB is on a site we work on. Every year during shutdown we try to persuade them to relocate and replace this board. It could go directly behind the wall into a store room.

Untitled

• Lectrician
• 18 May 2008
• 1

Untitled

• Lectrician
• 18 May 2008
• 1

Untitled

• Lectrician
• 18 May 2008
• 1

 

[GaryMo]

RF I have just had 6 pints of SHEEP, but is that an earth going to the 2nd pole of the Isolator?

It's a 4 pole isolator, from left to right: N - R -Y - B

 

[oharaf]

Good morning, yes can now make out the shadow and see it is a 4 pole isolator.

New rule don't work ****ed