Hi all, doing my 1st overlay system, it is 5mts by 3mts, at one end it is angled like a 50pence piece then runs down square, on the polyplumb technical drawings it shows to just square up the panels and not take it into the angle, is this correct or will it cause a cold spot? thanks in advance
polyplumb overlay board conservertory pipe run?
- Thread starter fishingblade
- Start date
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
