Depends on the type of plastic fitting, ie "O" Ring first or Grab Ring First (see post No. 11)
Pressure testing
- Thread starter CAESAR32
- Start date
Depends on the type of plastic fitting, ie "O" Ring first or Grab Ring First (see post No. 11)
Sponsored Links
18bar for polypipe stuff, 10-12 for most others. best to test at around 3 bar/working pressure for 10 mins before pumping up to full pressure as somebody else mentioned alittle dust or debris between an oring and pipe can hold at higher pressures sometimes but leak at working pressures. Thats why its important that plastic is installed in a clean workspace. makes me worried when i see somebody first fixing with all there fittings on the floor covered in dust/saw dust.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
