I got sent this Floureon one for review - it's not too bad actually:
https://www.amazon.co.uk/FLOUREON-Positioning-Detection-Connection-BT-54F/dp/B01M9INH7E
What connections do you have for the ptz ? ( old school 2 for data 2 for power and coax ) or power and coax only ? The ptz will need A an address normally 000-254 and a protocol e.g. Pelco p / d , may also need a baud rate
It may support hik vision coaxitron ( up the coax ) but you need to set the ptz for this
Does the ptz manual say what the default setting was ? Or did assume it was the same as the Swann ptz ? Have you set anything on the ptz ?
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local