Pyronix Enforcer 32-We alarm

[khunter]

Hello.
New to the forum and into this kind of diy.
I have a pyronix enforcer 32-WE and recently I changed the door sensor , and I don't know what I've done but even there's no error on control panel , landing and door is not triggering the alarm , not even when I've done a walk test , the landing and door is not appearing to be working. When I set the alarm , and close the door , the alarm is set but only in the sensors from downstairs. When I open the door , the alarm doesn't get triggered. I've performed a clean start from the engineer menu , relearned every sensor ,performed an signal strength and it came back 100% on any of them ,but the door sensor and landing pir still with no luck. Any advice would be apreciated. Thanks in advance.

 

[sparkymarka]

Changed the door sensor. . ? New one ?

 

[khunter]

Changed the door sensor. . ? New one ?

Yes. For same control panel. Learned it with the box also.

 

[sparkymarka]

So did you delete the old one , then relearn it in its place ? Or did you add it ? If so it’s going to be further up the zones ..