Hi I have removed a Thorn strip light and there are two sets of wires the connections were:
Cable 1:
Red to Live 1
Black Neutral
Green Earth
Cable 2
Red to Live 1
Black to Live 2
Green Earth
There are 4 connections on the Thorn (Live 1, Live 2, Neutral and Earth) and only three on the new light (Live Neutral and earth). There is only 1 Switch that controlled the strip light.
I have connected the Two lives to the single live and the black that was neutral to the neutral with both earths to earth (leaving the other live unconnected). This results in the light always being on. I have also tried just connecting cable 1 to the correct terminals but again the light is always on. Any pointers or ideas as to what is going on would be greatly appreciated.
Cable 1:
Red to Live 1
Black Neutral
Green Earth
Cable 2
Red to Live 1
Black to Live 2
Green Earth
There are 4 connections on the Thorn (Live 1, Live 2, Neutral and Earth) and only three on the new light (Live Neutral and earth). There is only 1 Switch that controlled the strip light.
I have connected the Two lives to the single live and the black that was neutral to the neutral with both earths to earth (leaving the other live unconnected). This results in the light always being on. I have also tried just connecting cable 1 to the correct terminals but again the light is always on. Any pointers or ideas as to what is going on would be greatly appreciated.