Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Hi guys, can someone help me trouble shoot this one. I have a wet underfloor heating system and one room is permanently on even when the stat is turned off. What would this indicate and what can I try to resolve?
There could be a few reasons, mis-wiring, flat batteries in a battery powered room stat, or zone actuator stuck or not fitted correctly to the UFH manifold. What system do you have?
Hi and thanks for the response, I've had a look into this further and one of the zone actuators appeared to have come loose. No. 8 on the attached picture.
The room is split into two (no8 and 7 on the attached picture.) and it would make sense that No.8 was causing the problem as after further investigation only one half of the rooms floor is hot.
Anyhow I've reconnected the actuator but the rooms temp does not seem to be decreasing either with this stat off or reduced to 5o's?
What would be my next step in trouble shooting this please.
It may take a little while for the temperature to drop especially if the pipes are in a thick floor. Is the flow indicator for that zone showing any flow?
They are the clear things in the lower part of your photo, the red/black marker inside moves up and down depending on the flow. They usually move about a bit as the water flows, but are stationary when the valve is fully shut. You can also check the valve actuator ring is screwed down properly by unclipping the actuator and checking the plastic mounting ring is hand tight. If it is loose the actuator won't be able to push the valve pin fully closed.
Thanks for that, yes it's only stuck on recently. I just checked the room again now and it's dropped a degree down to 19 so will see if it goes further overnight.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local