Hello,can somebody help me? i have a 9752 scantronic alarm with 2 keypads.
i want to have ability to arm, disarm, and arm it again (after alarm) home alarm remotely, with my phone. (without intering user pin on keypads)
Maybe somebody knows how that alarm works, because manual is not clear enought with this issue.
1. if i will connect keyswitch(just normal key,(not a 9928 keyswitch interface)) as a zone, will i be able to arm,disarm and reset panel after alarm (to arm it again) remotely?
2. if i will use 9928 keyswitch interface connected to panel?
3. if i will use remote keyfob with rfx08?
manual says:
"Wiring Keyswitches
To allow a user to set and unset the system using a keyswitch, connect a fixed position or spring loaded (momentary) key switch to a zone input. When programming the control unit select zone type (KM) for momentary or (KF) for fixed position keyswitches. See Command 185 for keyswitch auto-reset."
but in a zone description:
"The keyswitch or similar device can be used to set and unset the level or partition to which the zone is assigned. It cannot be used to reset the system."
also:
"185: Keyswitch Auto Reset
This command instructs the control unit to reset automatically if the user uses the keyswitch to set the system on leaving.
Option
0 1
Note:
Off (default). User must reset manually.
On. System resets automatically when the user sets it with a keyswitch (KM or KF).
Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) requires that Command 185 is set to option 0."
user guide does not have any option to reset panel after alarm except of entering access code
thank you
i want to have ability to arm, disarm, and arm it again (after alarm) home alarm remotely, with my phone. (without intering user pin on keypads)
Maybe somebody knows how that alarm works, because manual is not clear enought with this issue.
1. if i will connect keyswitch(just normal key,(not a 9928 keyswitch interface)) as a zone, will i be able to arm,disarm and reset panel after alarm (to arm it again) remotely?
2. if i will use 9928 keyswitch interface connected to panel?
3. if i will use remote keyfob with rfx08?
manual says:
"Wiring Keyswitches
To allow a user to set and unset the system using a keyswitch, connect a fixed position or spring loaded (momentary) key switch to a zone input. When programming the control unit select zone type (KM) for momentary or (KF) for fixed position keyswitches. See Command 185 for keyswitch auto-reset."
but in a zone description:
"The keyswitch or similar device can be used to set and unset the level or partition to which the zone is assigned. It cannot be used to reset the system."
also:
"185: Keyswitch Auto Reset
This command instructs the control unit to reset automatically if the user uses the keyswitch to set the system on leaving.
Option
0 1
Note:
Off (default). User must reset manually.
On. System resets automatically when the user sets it with a keyswitch (KM or KF).
Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) requires that Command 185 is set to option 0."
user guide does not have any option to reset panel after alarm except of entering access code
thank you