Hello,
I had my boiler replaced (and relocated) a few months ago and the old one removed but the cable (1mm) for the old immersion heater is sill in place, connected to a timer on the wall, and running back to a 15amp ceramic fuse in my wylex consumer unit.
I want to redecorate the bedroom where the old boiler was, and remove the timer, but i don't know what to do with this cable.
Would it be a bad idea to replace the timer with a mains socket ? or is the cable under-rated for that ? or what about a fused socket ?
I'm not confident enough to remove the cable from the consumer unit. I could leave the fuse out of the CU but i'm worried in case someone plugs one back in !
Any suggestions ?
I had my boiler replaced (and relocated) a few months ago and the old one removed but the cable (1mm) for the old immersion heater is sill in place, connected to a timer on the wall, and running back to a 15amp ceramic fuse in my wylex consumer unit.
I want to redecorate the bedroom where the old boiler was, and remove the timer, but i don't know what to do with this cable.
Would it be a bad idea to replace the timer with a mains socket ? or is the cable under-rated for that ? or what about a fused socket ?
I'm not confident enough to remove the cable from the consumer unit. I could leave the fuse out of the CU but i'm worried in case someone plugs one back in !
Any suggestions ?