Hi
I have a new shed in which I want to install a door magnet. I have run 8 core cable underground from the shed back to the control panel. From there, I have joined two wires (orange and orange/white) to two spare cables going to RKP 2 (blue and yellow). In RKP 2 I have connected blue and yellow into Zone 1 and bridged tamper. Set RPK 2, Zone 1 to map Zone 009 and set it to normally closed and guard.
For now, I have just twisted orange and orange/white together in the shed for testing. My issue is that Wintex shows as being Secure but when I untwist the cables in the control panel, it is still secure! If I enable 'Display zone resistance', I get a reading of 6.84k when cables are disconnected and when I connect them back together it shows 2.13k.
Anyone have any ideas of what could be going on?
I have a new shed in which I want to install a door magnet. I have run 8 core cable underground from the shed back to the control panel. From there, I have joined two wires (orange and orange/white) to two spare cables going to RKP 2 (blue and yellow). In RKP 2 I have connected blue and yellow into Zone 1 and bridged tamper. Set RPK 2, Zone 1 to map Zone 009 and set it to normally closed and guard.
For now, I have just twisted orange and orange/white together in the shed for testing. My issue is that Wintex shows as being Secure but when I untwist the cables in the control panel, it is still secure! If I enable 'Display zone resistance', I get a reading of 6.84k when cables are disconnected and when I connect them back together it shows 2.13k.
Anyone have any ideas of what could be going on?