Unsupported length of 27mm worktop

[MidsTW]

I’m going to have a 2.4 metre run of 27mm oak worktop.
I have a 600mm base unit at each end which the worktop will be screw to with slots to allow for the cross grain expansion.
In the centre of the 2 units will be a span of 1200mm for the washer dryer.
I was planning to run a piece of 34mm x 34mm timber along the wall to a) attach the units to as it all stands off for the plumbing etc and b) to provide a full then support for the worktop along the back edge.

Would this be enough to prevent sag, or should I fit an end panel between the integrated washer and freestanding dryer?

 

[footprints]

I would go for panel or chrome leg.

 

[Wayners]

Leg or panel between the two appliances.
You can buy a narrow leg vs one of those fat one's

 

[MidsTW]

Yeah I’m more inclined to go with the panel as it will probably blend in better with the cabinet doors etc

 

[JohnD]

If you use a panel that is not as wide as the units, it will not be seen.

 

[MidsTW]

Yeah I was going to bring it to the front, flush with the washer door to put it on show, otherwise I’ll need to leave a 20mm gap either side of the dryer which could look a bit odd?