Can anyone tell if you can sand down thin veneered wood and if so what grade sandpaper to use please?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Veneered wood
- Thread starter LizzieD
- Start date
Yes, but as modern veneered boards are extremely thin with the veneer layers between 0.4 and 0.8mm thick you'll need to be careful. Aluminium oxide paper at P120 or P150 grit should give a reasonable finish for further finishing.
Be sure to use a sanding block to back the paper. If you are machine sanding don't press down hard on the machine (a common error), just let the sandpaper do the work and keep the machine moving at all times. Be especially careful to support the machine near edges - there is a danger of dubbing over if you don't do this. If you stop moving the machine that's when you'll get a sand through and end-up showing the substrate
Scrit
Be sure to use a sanding block to back the paper. If you are machine sanding don't press down hard on the machine (a common error), just let the sandpaper do the work and keep the machine moving at all times. Be especially careful to support the machine near edges - there is a danger of dubbing over if you don't do this. If you stop moving the machine that's when you'll get a sand through and end-up showing the substrate
Scrit
Thank you so much for your very helpful reply
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
