I have a Veritas 8 Panel with one remote keypad. Decided to change keypad as numbers etc have worn away over the years [its been in since 1999].
The only slight problem is that there is no audible sound from the keypad when setting the alarm, just have to check with LED's that it has actually set.
I have trawled through the forum but the only reference I can is for marrying up an existing keypad to a new panel not the other way round.
This entails Entering Programme Code> press Prog>enter 00>press 8>press Prog>press reset will this work in my situation?
Thank you for reading this and any help or assistance will be greatly appreciated.
The only slight problem is that there is no audible sound from the keypad when setting the alarm, just have to check with LED's that it has actually set.
I have trawled through the forum but the only reference I can is for marrying up an existing keypad to a new panel not the other way round.
This entails Entering Programme Code> press Prog>enter 00>press 8>press Prog>press reset will this work in my situation?
Thank you for reading this and any help or assistance will be greatly appreciated.