As per the title. My neighbours have timber clad 2 extensions, one either side of the original stone building in (I think) 6" T&G larch. Looked fantastic, but the latest elevation (done when relations with the builder were frayed!) has bulged out in several places. What would have caused this, and why only this bit? What needs to be done? All off and redo?
Vertical Timber Cladding Bulging Out
- Thread starter charliegolf
- Start date
no way off telling with out getting intrusive but typical causes load on the top bellying out the cladding to allow the length to reduce or a structural component pushing out??
try to push the bulge flat and level and see what you find
try to push the bulge flat and level and see what you find
Thanks for that. If looking down on the timber, the worst bulge would be close to 90 degrees- it's like flippin corner made of wood!
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
