Wintex and Part Arms

[craftycooky]

Please could somebody advise how I modify part arms in Wintex, seem to have a mental blank on this.

Only have Area A and have set up part arms using the keypad by omitting zones, eg to allow Garage and/or Downstairs to be armed at night.

Cant find how to change this in Wintex.

Thanks

Dave

 

[T1GERIII]

Zones and Attributes ,
Select Zone and assign it to which ever area you want it to be active in A B C D using the toggle options on the right hand side

 

[craftycooky]

Zones and Attributes ,
Select Zone and assign it to which ever area you want it to be active in A B C D using the toggle options on the right hand side

Thanks, sorted it now.
Dave

 

[sparkymarka]

Not the way I would do it .... tick part 1 / part 2 / part3 omit in zone config

 

[craftycooky]

Not the way I would do it .... tick part 1 / part 2 / part3 omit in zone config

Thanks, that's what I did in the end, couldn't find where the part arm check boxes were.
Thanksfor your help
Dave

 

[secureiam]

The only time a zone should be in multiple areas in Premier/ Premier elite is latch key or moment key where you are setting multiple areas using the one zone.