Wiring help.

[Chris J]

RM Cylinders dual thermostat can it be wired to operate as a on and off for a zone valve with out any connection to the programmer/control of the boiler ? If yes how would it need to be wired?

 

[Deleted member 267285]

They work from the programmer to the cylinder thermostat and then to the zone valve. How is it wired currently?

 

[Chris J]

They work from the programmer to the cylinder thermostat and then to the zone valve. How is it wired currently?

It's not ,reasoning behind the question can it be done?

 

[Chris J]

I was thinking something like this:

 

[Deleted member 267285]

I guess it could work, but not good practice, and you’ll so have a permanent live at the cylinder thermostat.

 

[Terrywookfit]

I guess it could work, but not good practice, and you’ll so have a permanent live at the cylinder thermostat.

What is the problem with that? Lots of things have P\l

 

[Deleted member 267285]

What is the problem with that? Lots of things have P\l

No problem, just highlighting it. I’m not as experienced as some in wiring department

 

[picasso]

How do you control the boiler if there is no connection to it ?

 

[Chris J]

How do you control the boiler if there is no connection to it ?

It's a pellet boiler that's a self contained unit. Works on the returning water temp as rads shut down the returning water gets hotter so less heat is produced by the boiler until it shuts down, when returning water cools it starts up again.

 

[Chris J]

I guess it could work, but not good practice, and you’ll so have a permanent live at the cylinder thermostat.

Can you explain why it's not good practice and I can't see why a permanent live should be a problem.

 

[picasso]

Fairly sure you cant connect an unvented cylinder directly to a solid fuel boiler but stand to be corrected.

 

[Chris J]

Fairly sure you cant connect an unvented cylinder directly to a solid fuel boiler but stand to be corrected.

Your reasoning behind this ?

 

[Deleted member 267285]

Can you explain why it's not good practice and I can't see why a permanent live should be a problem.

No I can’t, so I guess it’s ok practice, as I said in my reply to Terry, I’m not as good at wiring as others, and Terry also said it was ok.