Tips please on cutting a hole in a worktop for a built-in 4-ring gas hob.
When doing a similar cutout for the sink, I used the upside down sink as a template.
For the gas hob, I will probaly have to use the existing worktop as a (heavy!) template. However, the new worktop is not quite as wide, so I will have to be very careful.
Thanks
Mike
When doing a similar cutout for the sink, I used the upside down sink as a template.
For the gas hob, I will probaly have to use the existing worktop as a (heavy!) template. However, the new worktop is not quite as wide, so I will have to be very careful.
Thanks
Mike