Hi all!
When replacing a CU and insall a split load RCD protected board the circuits are divided into 2 groups to minimize disruption in the event of a fault on a circuit, but is this a must???
I as because I have a CU to replace next week but it only has 1x 32A for Ring Main, 2x 5A for lighting and a 15A for Emersion Heater.
Even if there are such few circuits would a Twin Rcd Split board need to be installed??
Any advice appreciated!
When replacing a CU and insall a split load RCD protected board the circuits are divided into 2 groups to minimize disruption in the event of a fault on a circuit, but is this a must???
I as because I have a CU to replace next week but it only has 1x 32A for Ring Main, 2x 5A for lighting and a 15A for Emersion Heater.
Even if there are such few circuits would a Twin Rcd Split board need to be installed??
Any advice appreciated!