Conex Cupro push fit

[MikeyGas]

Evening Gents, am tidying up some Flow and Return pipes for a customer and access for soldering is a no-go. Any info on using the above fittings? In the past if I've had to use pushfit it's been Hep2o all the way, but i'm keen to try out new materials. Cheers

 

[gigz]

If these are the same as techtite (brass body) they're good but a bit pricey

 

[MikeyGas]

Yeah there brass body, fittings are a couple of quid a pop Do you think they are superior to plastic pfit fittings?

 

[dextrous]

Other than appearance, I see no advantage of using these over the usual plastic stuff since the innards will be the same and ultimately that's all that matterss

 

[kevplumb]

Other than appearance, I see no advantage of using these over the usual plastic stuff.

yup same rubber ring

same grab ring

must admit they do look better tho

 

[dextrous]

Other than appearance, I see no advantage of using these over the usual plastic stuff.

yup same rubber ring

same grab ring

must admit they do look better tho

Indeed, it will make it look a bit more like "you've had a professional come round"

 

[SuperMario80]

might depend where they are going though.. As I've been to a job in the past where a squirrel had chewed through 2 speedfit plastic elbows!

 

[MikeyGas]

Thanks for all the input guy's