Hi guys
Upgrading from Honeywell tr6 to evohome.
Target setup is quite simple for time being.
1 zone heating, and hot water tank on a sundial s plan. Essentially what tr6 was doing.
Tr6 essentially has 2 output connectors, one for hot water demand and one for heating.
I got 2 relays BDR91, one to drive each wire.
Question is I cannot for the life of me get evohome to manage these independently. Best setup I've managed is when there is heating demands, the relevant BDR91 triggers, but when's there's hot water demand, both bdr91s trigger.
It seems evohome thinks the heating relay controls the boiler. But in this case, both wires trigger the boiler so need to drive each BDR91 independently. Any thoughts?
Upgrading from Honeywell tr6 to evohome.
Target setup is quite simple for time being.
1 zone heating, and hot water tank on a sundial s plan. Essentially what tr6 was doing.
Tr6 essentially has 2 output connectors, one for hot water demand and one for heating.
I got 2 relays BDR91, one to drive each wire.
Question is I cannot for the life of me get evohome to manage these independently. Best setup I've managed is when there is heating demands, the relevant BDR91 triggers, but when's there's hot water demand, both bdr91s trigger.
It seems evohome thinks the heating relay controls the boiler. But in this case, both wires trigger the boiler so need to drive each BDR91 independently. Any thoughts?
