baxi

Hi all, I'm new to this so I will get to the point and try to be clear as possible. I'm currently trying to install a Nest Thermostat E with Heat Link to a Baxi Combo Duotec 28. There is currently a Horstmann Hrt4-zw attached with the wiring below for the wireless receiver. Now how do I...

Hello all. Been babysitting an old Baxi105e for three years and it's not a disaster but a bit temperamental. Current niggle : first time in the day, the CH side only fires up if the Hot water is run at the tap first for a few minutes. On turning the hot tap off the CH smoothly takes over and...

Dear all, Just moved to new home.... I have a Baxi combi boiler; fairly new and a "Center" 7 day programmable Room stat. This is located in the dining room https://www.wolseley.co.uk/product/center-7-day-programmable-room-thermostat-230-v/ also On each of the radiators we have a "Myson TRV 2...

Hi ive got a question having the flue set up this way is safe with this boiler or should it be just horizontal, going up its around 51cm ive been told today by RGI that this is wrong but have been running it for 2 years

Hello so ive got a problem i replaced a fan because it wasnt running at all now the problem is when i put on the front cover the boiler wont turn on but when i loosen it a bit it ignites no problem any ideas what could be the problem?.

Just need to confirm that this will work before I buy... I have one cable coming out of my Baxi Platinum Combi 28 HE boiler into a Salus RT500RF receiver. I want to install Hive so is it just a case of L to L, N to N, Earth to Earth and COM to No1 on the Hive? I would imagine that I would need...

Hi all. Spent some time in this forum trying to find the solution for this problem and got many tips, but the boiler is not working properly. When I first noticed the water sandwich the pressure was below 1. Managed to fill it up, and the meter was increasing really quick but slowly going...

Hi all New to the forum and looking for a little help I have a baxi duo tec he and I want to install a nest thermostat gen 3 at the moment I have a baxi multifit wireless programmer fitted do I need to disconnect this before the nest is installed and if so do I link the two wires that go into...

Hi all, I have been trawling the internet trying to get some information on how to connect a nest to my new boiler, i live in Spain and the instructions for the boiler don't seem to be available in English... Baxi didn't either bother to reply! as i understand it the Baxi have the usense ubit...

Hello everyone, hope you are all good. I’m having a problem extending the horizontal flue. I have built an extension and want to extend the horizontal flue by 4m. The boiler is a Baxi NetaTec 33GA and in the specs it says a 60/100 flue length up to 10m with a deduction of 1m per 93 degree bend...

Could someone help me with the issue I have with my boiler please. When in Central heating mode the boiler will fire up for a few minutes but the pump runs constantly - even with the dial on the lowest setting. Is this a characteristic of this boiler or a fault? In my old house there was a...

Hi Guys. I have a Baxi 105 HE. We have an issue where the boiler doesn't come on for the hot water. It does come on when you turn both the basin and bath taps on to full flow. I assume there is a flow valve/switch that detects when the water is flowing. My questions are: 1. Where is it on the...

Hi, I was wondering if anyone could help with an issue which has started on my ancient yet trusty boiler. I've recently noticed that it seems to have trouble with the flame and will sometimes have to reignite. This seem to be happening only when heating the hot tap and not central heating...

Hi all, My boiler was flashing with an E9 error this morning as is reading 0 bar pressure; but when i topped up using the filling loop the needle didn't move. Could hear water going in, then can hear not much more really able to go in, so have let a bit out of the boiler so not too high (and...

Hi, we've got a Baxi Heating Solo 2 50 PF gas boiler at our flat and it suddenly stopped working a few days ago. The agency claims that we 'tampered' with the exposed wires near the boiler knob (see attached pic) and that now it's beyond repair, and a new one has to be installed. Basically, the...

Hi Can anyone help me with how to wire a hive dual channel receiver to a Baxi Platinum? I know it should be a single channel receiver but is it still possible!? See attached wiring diagram for the boiler and hive Thanks

Hi, I have purchased and attempted to install a Hive Gen 3. The existing set up was a thermostat (Drayton Tempus 7) and a WR 1 thermometer. Looking at the existing install and the wiring diagrams with the hive booklet I have assessed that I have an S-Plan configuration. So I have powered...

The problem I'm having is that occasionally, when the heating is switched on, the green 'radiator/heating' light comes on on the boiler, but not the amber 'flame' light. While the boiler is on this state, radiators don't get warm. If I turn the boiler off and back on, the heating kicks in as...

Hi, I have this boiler in a house I just moved into, for the first week boiler was fine, now it doesn't fire up unless its reset about 4 times, pump comes on, fan comes on, gas valve clicks, but only a tiny flame, then goes out, each time I reset it the flame gets larger,, and as I said...

Hi Folks, I am replacing installing a Salus IT500 onto my current Gas Boiler. I'm pretty sure that my wiring is correct (but could be mistaking) When I select Manual the Boiler comes on and works using the Boiler Thermostat but when I go to Auto the light goes out and boiler shuts off. I...