repair

I have a table saw which has stopped working.smoked once from the relay. Now if I try to restart it. Motor goes very slow if switched kept pressed in otherwise if just pushed motor goes for a second and stops. Can the relay be repaired or need to be replaced? I have attached photos of the...

Hello there, Thanks for reading this - As the title suggests, I have a Trianco TRO 15/19 oil fired boiler, which has currently stopped working. The boiler has come to a complete stop, normally there is a green light to indicate mains supply and then when I switch the programmer to turn on...

Just noticed I have a leak from my flat roof right in the corner of the room. Need a temp method of repair to stem the ingress of water. Weather is foggy and damp, it's a north facing garden and I hear a asteroid is about to hit my location. Putting aside the asteroid disaster for a minute...

The spring has gone on the kitchen door (bog-standard council, cheap) lever handle, but I'm not seeing how to reach the spring to replace it. As you can see from the photo, there's a metal plate inside covering it. It looks welded on and turns with the handle. Does this mean these are...

Hi, Front bedroom Artex ceiling is damaged from past leak, couple of bits where it sticks downwards and there is a crack from wall to wall, possible to repair? Or job for a plasterer? Other rooms have cracks wall to wall which I assume are between the plasterboard sheets.. is there an easy...

Hello all! During lockdown in April we moved into a new house and on day 1 found a gas leak which required a new boiler system. Our options were limited due to full lockdown so we got in touch with the closest boiler installation guy we could find, willing to work during the lockdown. Long...

Hi all, I'm after some advice please. The lintel above my garage door is cracked (see pictures) and needs replacing (along with the garage door). The garage roof is pretty thick concrete... I've had 2 builders come round so far to look at the job, the first one says that as the lintel and the...

Location: UK Here is one of the original tiles. No idea what it is called in order to obtain a replacement. However, the idea is to repair one that is broken using a strong adhesive. Any advice on the best adhesive to use would be appreciated. Thanks in advance. Roof cap tile by Ryck...

Does anyone know of a good product for repairing the enamel where an integrated oven mounts to the unit? I bought an ex-display unit and someone has managed to damage it in the process of removal Enamel is a gloss grey and I don't need much but not sure which products are suitable and not too...

I had Vinyl flooring fitted in my kitchen in 2015. A few days ago I cooked myself a baked potato in the microwave (as I have done many times before!). However, after ten minutes (2 x 5 minutes) + 2 minutes cooling; the potato was black! Therefore I put the potato in the bin and microwaved...

I am looking to repair the external architrave to my front door. Its my last attempt before ripping out and replacing with a composite (which I would really, rather not do) and im hoping that I can repair, rather than replace the architrave. I have my wet rott hardner and epoxy exterior wood...

My commercial grade Numatic hoover has stopped working. I checked switch and capacitor and all seems working fine. Machine was working and then stopped. With new fepa filter was under a bit of overloading but I only used for few minutes a time to use with wall chaser. I do not see any other...

Hi Guys First post on this forum, looking for some advice and guidance. Currently tidying up the appearance of my parents house. It is an ex local authority semi detached house built in the 1930/40’s (i think). Most of the house is rendered apart from the lower section of wall where 5 rows...

I found out that the ceilings on my first floor were renovated but the laths were kept and pins were used instead of screws. My first question. Is it worth to remove the old plasterboard attached to lath and replace with a fresh one and maybe just tape and joint or new plaster? Why the lats...

Hi guys, Our backdoor patio (backdoor) handle has progressively been getting worse. anytime someone pulls in the door to close, the handle will come off (shown in one of the photos). All we can do right now is jiggle it back in. the door is either a double glazed or triple glazed glass panels...

Hi all, We have a brick wall in our garden, which kind of supports a walkway above it, but it's in need if some TLC. I think standard pointing will do for the most if it, but there is one bit that I'm not sure if just filling it with mortar is ok. I've attached a pic of the offending peice of...

Hi DIY-ers, I want to repair the wooden frame around a badly installed lock. I am happy for the lock to remain, but am not sure how best to fill the badly carved out gaps in the doorframe around it. See pictures to understand. The largest part is 3cm wide X 2cm deep. I've thought of cutting...

Hi I've got a stone resin shower tray like the one in the link below: https://www.amazon.co.uk/Rectangular-1200x900mm-Stone-Shower-Enclosure/dp/B005AFVYSW/ref=sr_1_5?keywords=shower+tray+1200+x+900&qid=1556089283&refinements=p_89%3AiBathUK&rnid=1632651031&s=gateway&sr=8-5 Its got a chip in the...

Hi, Got a cast iron downpipe with a broken collar, when it rains quite hard the water spills out of the broken section. I know it may be best to replace but is there a way that a good quality repair can be facilitated? The back of the pipe is rusty but no leaks as far as I can see. Thanks...

Would a bituminous roofing felt adhesive be suitable for priming a (cut) tarmac edge, before laying some cold repair tarmac down adjacent to it? It has to be a better job if a primer or edge sealant is used but the spray-on stuff is quite pricey. I was thinking of using something like...