- Joined
- 11 Jan 2020
- Messages
- 9
- Reaction score
- 0
- Country
Hi, i have just installed an 8XE expander (direct plug onto the pcb).
Have wired an additional 3 zones onto it.
How do i now set it up in wintex?
when i click on zones i see zones 1-8 with location as Panel, but then 9-24 is "N1 E1 Z1" etc
If i use the keypad and view zone status it shows me 1-16 but 9 onwards is listed as tamper, so i think it is seeing the expander connected but i cant figure out how to see it in wintex.
Please advise.
Thanks
Have wired an additional 3 zones onto it.
How do i now set it up in wintex?
when i click on zones i see zones 1-8 with location as Panel, but then 9-24 is "N1 E1 Z1" etc
If i use the keypad and view zone status it shows me 1-16 but 9 onwards is listed as tamper, so i think it is seeing the expander connected but i cant figure out how to see it in wintex.
Please advise.
Thanks