Hi everyone I have an ADT wired alarm which has not been used for 3 years, it’s just on standby using electricity is there anyway I can disconnect it or do I need an electrician, or does adt need to disconnect it, any advice would be helpful thank you
No …..remove that fuse in the daytime …..open the box and pull one of the battery spade terminals off …..now it may ring for 20 mins ….or not as adt don’t always fit external bell boxes ….( just dummies )
doing what Sunray says may cause it to activate in the night when the battery runs out
No …..remove that fuse in the daytime …..open the box and pull one of the battery spade terminals off …..now it may ring for 20 mins ….or not as adt don’t always fit external bell boxes ….( just dummies )
doing what Sunray says may cause it to activate in the night when the battery runs out
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local