1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

After adding a PIR to Pyronix Euro 064 - LCD keypad how do i add it to the system (Euro 46 v10)

Discussion in 'Alarms, CCTV & Telephones' started by Bongo1, 9 Jul 2020.

  1. Bongo1

    Bongo1

    Joined:
    9 Jul 2020
    Messages:
    2
    Thanks Received:
    0
    Country:
    United Kingdom
    I have completed a replacment of my old Pyronix alarm system to a new feature packed Pyronix Euro 64 v10 with th Keypad Eur-064. I have managed to configure all 8 onboard zones (imputs), the bell & the keypad. The only issue I am facing is that I now wish to add a PIR using one of the 2 Keypad imputs (zones). I have wired in the a new Pyronix PIR but I can not find the next steps to add it to the system. Should the new PIR be configured as input09 or are there any other steps I need to perform 1st?
     
  2. Sponsored Links
  3. Handymanjo

    Handymanjo

    Joined:
    2 Feb 2016
    Messages:
    1,518
    Thanks Received:
    284
    Location:
    Newark
    Country:
    United Kingdom
    Keypad address 0 zone input 73 and 74
    Keypad address 1 zone input 75 and 76
    So zone 1 on keypad 0 will be zone 73 and zone 2 on keypad 0 will be zone 74.
    Keypad address 1
    Zone 1 on rkp will be zone input 75 and zone 2 on rkp wil be input 76
    Hope this sorts your problem
     
    • Like Like x 1
  4. Bongo1

    Bongo1

    Joined:
    9 Jul 2020
    Messages:
    2
    Thanks Received:
    0
    Country:
    United Kingdom
    Fab thanks that worked thought I was on the right lines just could not find the input numbers documented anywhere.
    Thanks again system all up and running now :)
     
Loading...

Share This Page