I should have paid attention to how the old extractor was wired in but I didn’t. I’m now finding that my extractor is running continuously.
It has 3 terminals: L,N,T
I have 3 wires in the supply side: live, neutral and switched live (connected to light switch)
I put the live into the L terminal, Neutral in N and Switched Live into T.
Can you please advise on where I’ve gone wrong.
Thanks in advance
It has 3 terminals: L,N,T
I have 3 wires in the supply side: live, neutral and switched live (connected to light switch)
I put the live into the L terminal, Neutral in N and Switched Live into T.
Can you please advise on where I’ve gone wrong.
Thanks in advance