Hi there. Just finished installing a texecom premier elite alarm system. The system was sitting nice and tidily with no faults. Thought I would do my first set and trigger the pir in the hall to create an alarm situation. I did this successfully but could not reset the system. It came up with bell tamper on the keypad. I have already manually tested the bell and strobe successfully. As it Was the end of the day I powered down the panel and let the bells time out. Any ideas what it could be before I go back on Friday.? First port of call will be looking at the lid tamper on the bell boxes.
bell tamper
- Thread starter Davisss
- Start date
Sponsored Links
A very long cable run to the SAS can cause this kind of fault due to voltage drop when the siren sounds - when in Engineer mode all tampers are isolated so your "bell test" may not have shown the fault 
OR bell microswitch not bent out , when bell sounds it vibrates causing tamper.....
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
