hi, can anyone pls help, im new on here and need some advice, i woke up this morning and went to turn my boiler on but it wouldnt start up, and there was no hot water either, it has had a new fan less than 12 months ago and i can here it start up, also it makes a few repeated ticking noises but it doesnt ignite, the gas supply is ok, i used to be able to see the spark but i cant see it now, would the problem be the circuit board or an igniter or could it be something else, any advice pls, thanks Dan
biasi boiler problem
- Thread starter dantheman33
- Start date
hi, thanks for reply, yes the bar has gone down to zero, its at 0.2 but i think its resting on the zero pin. also the plugs are in place, thanks
also, the relay switch that works the ignition clicks like mad when you press the on switch, but it doesnt seem to spark inside the boiler itself
repressurise by putting the water in?
ive pressurised the water back up and pressed the little reset button but it still makes the same noises and doesnt light up,,,thx
is it the reset button below the timer switch or is there another reset button some where, (sorry for sounding abit of a numpty, lol
hi, thanks for getting back again, ive found the overheat with the slot. Do i turn the slot or is there some other way to reset it, under the pressure gauge there is a tiny reset button, that is the one i pressed. thanks again. Dan
the model of my boiler is m24s 90e, hope this helps, thanks
It would have helped if you had mentioned the model at the start.
As you did not I thought you had the earlier 24S model.
In spite of you saying you have an M24S 90E in reality you have an M90E 24S
What year was the boiler installed or what is the serial number?
Does the red central lockout light come on?
Tony
As you did not I thought you had the earlier 24S model.
In spite of you saying you have an M24S 90E in reality you have an M90E 24S
What year was the boiler installed or what is the serial number?
Does the red central lockout light come on?
Tony
hi, sorry i didnt mention the model before and (yes i got the model number the wrong way round). i only realised when i took the side panel of and it was written inside, the year is 2002 but i dont know what year it was installed, and the s/n n223491102, i know its an old boiler but it has been reliable up to now. the red light doesnt come on which it normally does when the gas goes off. also the green light flashes more than normal. thx Dan
ive had an engineer out today and he said the pump is broke, he said it was just the front part that needed replacing but you have to buy a full pump at a cost of £170, as they dont sell any parts for them, is this correct, thanks Dan
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
