Can anyone advise if my problem is the inlet valve/solenoid or master board? Machine wont fill on wash cycle - water runs in for about 4 seconds then stops. Works OK on prewash and rinse - which uses the upper of the dual valves, main wash works off the lower valve. My confusion is the initial 4 second burst on main wash - then nothing. Could this be a main board issue?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
bosch front loader inlet valve?
- Thread starter kf5
- Start date
If you have a multimeter you can do a resistance check on the water solenoid valve terminals. On a medium or high resistance range with the wires disconnected from the water valve you should get about 3000 ohms. If one of them shows infinity ohms you know the solenoid coil has failed.
Both appear to read around 4000 ohms???
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
