Hey there, Wondering if someone could give me a hand with wiring up a Hive to my combi boiler. The current wiring looks like this, boiler wires on the left and power and thermostat on the right. Its all just wired into a big connector. The boiler has 2 black wires rather than a black and grey so I can't tell if they do different things.
I've read loads of posts and watched loads of videos but can't figure out what I should be doing with my Hive receiver. Is it simply a case of doing it like the diagram below ? Some of the posts on here are saying to put a wire connecting L and 1. In that case which black wire goes into 3 ?
Any pointers would be hugely appreciated
I've read loads of posts and watched loads of videos but can't figure out what I should be doing with my Hive receiver. Is it simply a case of doing it like the diagram below ? Some of the posts on here are saying to put a wire connecting L and 1. In that case which black wire goes into 3 ?
Any pointers would be hugely appreciated
