Just a quick question
table saw blade spins which way ???
hope thie is not a realy daft question
marty
table saw blade spins which way ???
hope thie is not a realy daft question
marty
"i always thought the blade came down at the front to h
- Thread starter gatesmr2
- Start date
Round and round 
B
breezer
depends which side you stand
but i think it spins towards you
but i think it spins towards you
Stand on the left hand side of the machine, and the blade spins clockwise,
and the teeth cut downwards at the front.
and the teeth cut downwards at the front.
agree with the above, if the blade snatches the workpiece, it is flicked away from the user.
unless it travels past 180 degrees that is. 
unless it travels past 180 degrees that is.
the teeth always pull the work towards the baseplate/table at the feed in point whether its a jigsaw a circular saw tablesaw chopsaw with the odd exception like worktop down cut blades in a jigsaw
http://www.screwfix.com/sfd/i/cat/pdfs/11/p4754811.pdf
even if you installed the blade on backwards it will still push the work onto the table at the front as it burns/rips it way through the workpeice
if the blade is comming up at the front its not only wrong its dangerous
http://www.screwfix.com/sfd/i/cat/pdfs/11/p4754811.pdf
even if you installed the blade on backwards it will still push the work onto the table at the front as it burns/rips it way through the workpeice
if the blade is comming up at the front its not only wrong its dangerous
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local