I’ll be fitting a new kitchen soon and my hob will be moving. The new location for the hob will be underneath my current 3 gang kitchen switch panel (Washing Machine, Dishwasher, Fridge Freezer) and too close to a current double gang (pictured) so both will need moving about 700mm to the right.
The are on an outside wall so will need channeling out I assume but the wall will be tiled afterwards.
I was going to use Wago 221 connectors to connect the extra length of cable in the back box and channel it to a new box and socket etc. but would appreciate some advice on the best way of doing this job.
I should state I’m not a qualified electrician but I’m confident and competent enough to do this. I just want to make sure it’s done correctly.
Thanks in advance.
The are on an outside wall so will need channeling out I assume but the wall will be tiled afterwards.
I was going to use Wago 221 connectors to connect the extra length of cable in the back box and channel it to a new box and socket etc. but would appreciate some advice on the best way of doing this job.
I should state I’m not a qualified electrician but I’m confident and competent enough to do this. I just want to make sure it’s done correctly.
Thanks in advance.
Last edited: