Leaking from the threaded fittings

Joined
12 Jul 2011
Messages
465
Reaction score
16
Location
Stirlingshire
Country
United Kingdom
A newly installed ballcock valve with 3/4" threaded fitting is connected to a 90 degree female elbow connector.
Put usual 3-4 turns of PTE tape on the ballcock thread fitting part and the paste around as well, and tightened up. It has been tightened to the point, where ALMOST it doesn't go any further tightening.
But when the water is going through, there is drops of water leaking from the bottom of the joint between the threaded male end of the ballcock valve, and the 90 degree female threaded elbow connector.

threaded fitting.jpg


What would be the best option to fix the leakage? I was thinking a few options here.

1. Give another turn of tightening (But it is already tightened NEAR enough I feel.)
2. Take out the ballcock valve, clean up the thread, and rewind PTE tape with paste, and refit. (This is what has been done. Is there a point for this try?)
3. Can it be the faulty ballcock valve or the 90 degree female threaded elbow connector? (Replace them with new ones?)

Thanks in advance.
 
Last edited:
You have two parallel threads. And you can only wind the fitting on in 360° increments.

Loctite 55 thread is far better than ptfe tape in this situation.
 
Score the male threads with a hacksaw if the tape is bunching up.
Wind the tape to form a taper...absolutely no need for paste.
If you still can't sort it then use Loctite 55 as mentioned (you can also back if off if necessary).
 
Yes, Loctite 55 rings a bell. It seems being used for this type of situations often. Thanks for the info.
1794763791267.png


Some say making PTE tape into taper, and wrapping around the threads does the same job.
 
This video seems to be a good demonstration on the critical points for wrapping the PTE tape on the thread.


Might have to take out the male threaded fitting, clean it up, and rewrap PTE.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top