Leaking from the threaded fittings

Why don't you just swap that fitting for a bent tap connector and fibre washer ?
The nut and olive on your existing pipe will probably screw straight onto the tap connector....job done.

Sure. Sounds like a good idea. Do you have links for the actual product? It is 3/4 to 22mm 90 degree elbow connector.
 
Sure. Sounds like a good idea. Do you have links for the actual product? It is 3/4 to 22mm 90 degree elbow connector.
Are you sure it's a 3/4 x 22mm ?.. most domestic ballvalves are 1/2 inch and fed by a 15mm pipe.
Just google tap connectors, they come in 1/2 or 3/4.
 

Attachments

  • Screenshot 2026-11-16 092013.png
    Screenshot 2026-11-16 092013.png
    24.7 KB · Views: 1
Are you sure it's a 3/4 x 22mm ?.. most domestic ballvalves are 1/2 inch and fed by a 15mm pipe.
Just google tap connectors, they come in 1/2 or 3/4.

In this house, the old ballvalve has 3/4 inch threaded fitting which goes to 3/4 female threaded connector. Because the water tank has a hole for 3/4 inch fitting, I had to buy a new 3/4 inch ball valve recently, and replaced the old one. It goes to 22mm pipe.
 
Last edited:
In this house, the old ballvalve has 3/4 inch threaded fitting which goes to 3/4 female threaded connector. Because the water tank has a hole for 3/4 inch fitting, I had to buy a new 3/4 inch ball valve recently, and replaced the old one. It goes to 22mm pipe.
So you need a 3/4 inch bent tap connector. As in the picture above but 3/4 inch x 22mm. Your nut and olive should fit straight on it. If not then change the nut as well.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top